DM9010

The DM9010 is a 10/100M fast Ethernet local bus network controller. It is designed with low power and high performance process that support 3.3V with 5V IO toleranc

• 100-pin LQFP

• Supports processor interface: Byte/word/Dword of I/O command to internal memory data operation

• Integrated 10/100M transceiver with HP Auto-MDIX

• Supports MII and reverses MII interface

• Supports back pressure mode for half-duplex mode flow control

• IEEE802.3x flow control for full-duplex mode

• Supports wakeup frame, link status change and magic packet events for remote wake up

• Integrated 16K Byte SRAM

• Build in 3.3V to 2.5V regulator

• Supports early Transmit

• Supports IP/TCP/UDP checksum generation and checking

• Supports automatically load vendor ID and product ID from EEPROM

• Supports 7 or 23 GPIO pins

• Optional EEPROM configuration

• Very low power consumption mode:

• - Power reduced mode (cable detection)

• - Power down mode

• - Selectable TX drivers for 1:1 or 1.25:1 transformers for additional power reduction

• -Lan Transformer  100Base-TX and 10Base-TX  YL2J201A   or  YT18-2601S or 16YM001
  

• - 1: 1 transformers only when HP Auto-MDIX Enable

• Compatible with 3.3V and 5.0V tolerant I/O

DM9010+YT37-1107S+RJ45

DM9010+YT18-2601S+RJ45

DM9010+YL2J201A

DM9010+16YM001+RJ45

DM9010+YL2J011D